Aaron's Homepage Forum
Aaron's Homepage Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Electronics
 Electronics Repair
 2030 bridge

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File (GIF, JPG, JPEG, BMP, ZIP, PNG)

   

T O P I C    R E V I E W
Ashirdaniel Posted - Apr 19 2017 : 04:13:15 AM
Can anyone explain how a tda2030 bridge amplifier works.the circuit is in its datasheet. Works on 12v dual supply. Produce 35watts RMS. I'm a beginner. Please.
3   L A T E S T    R E P L I E S    (Newest First)
audioguru Posted - Jul 14 2017 : 1:38:11 PM
Why are you asking about resistor values that are all shown on the datasheet for the TDA2030 and the TDA2030A??
Ashirdaniel Posted - Jun 26 2017 : 10:57:52 AM
So the output of top amplifier is send to the input of second amplifier. Which value of resistor is needed to connect them?
audioguru Posted - May 04 2017 : 7:24:32 PM
The output of the top amplifier feeds the negative input of the bottom amplifier so their output voltage swings are doubled. With a +/-12V power supply The top amplifier output swings to a peak of +9V when the output of the bottom amplifier swings to a peak of -9V. Then the 8 ohm speaker gets 20W RMS just before clipping. When the supply is +/-16V and the distortion is very high then the output is 34W.

Aaron's Homepage Forum © 1995-2020 AARONCAKE.NET Go To Top Of Page
This page was generated in 0.05 seconds. Snitz Forums 2000