Pine Racecar Victory Judge


Home > Circuits > Other > Pine Racecar Victory Judge Buy Me A Coffee
Author Views Views Today Rank Comments
104,636 1 1
I have received countless emails asking for a circuit to tell the user which car won in a pine car (also called Pinewood Derby, Cub Car, Scout Car, etc.) race. This simple circuit takes care of the guesswork, lighting the appropriate LED to indicate the winner.

Schematic

Schematic of Racecar Victory Judge

Parts

Part
Total Qty.
Description
Substitutions
R1, R22100 Ohm 1/4W Resistor
R3, R42100K 1/4W Resistor
D1, D22Standard LED
SCR1, SCR226A, 200V SCR (such as the 106B)
S1, S22See Notes
K11Small 12V Relay
MISC1Board, Wire

Notes

  1. S1 and S2 are small lever type micro switches. Most any kind will do, as long as they are sensitive enough to be activated by the wheels of the cars. They should be positioned on the track so that the front wheels of the cars will run over them as the cars just cross the finish line.
  2. To reset the circuit, disconnect and then reconnect power. You can add a normally closed switch in series with the power supply to make this easier.
  3. There is no reason this circuit cannot be used to tell the winner of a foot race, bike race, slot car race, etc.

Related Circuits

Air Flow Detector, Wire Loop Alarm, Simple Two Speed Contactor DC Motor Controller , 7 Segment LED Counter, Simple Lie Detector, Low Voltage Alarm, Video Stabilizer/MacroVision Removal, Pulse Width Modulation DC Motor Control, Simple Polarity Tester, Pine Racecar Victory Judge, Rain Detector, Time Delay Relay, Time Delay Relay II, Stepper Motor Controller, Touch Switch, Video Activated Relay, Digital Keypad Combination Lock, AC Motor Speed Controller, Simple Servo Controller, Water Detector With Sump/Bilge Pump Controller, Simple Touch Switch

Comments

Add A Comment

Jacob
Pine Racecar Victory Judge
Saturday, February 19, 2011 5:56:43 PM
What is the relay's purpose in this circuit?

Back To Circuits Page | Mail Me | Search | Buy Me A Coffee